Built-In
Gas Hob Repair & Service in Mira Road, Dahisar and Borivali
A built-in hob sits flush in the kitchen platform, which makes it look excellent and makes it awkward to service. Sealing gaskets perish, the auto-ignition module weakens, and spillage finds its way under the glass. Sunny services hobs in place wherever possible, and lifts the unit properly — without damaging the granite cut-out — when a fault needs access from below.
Call us if you notice
- Auto-ignition clicks continuously or does not spark at all
- One or more burners will not light on the first attempt
- Flame dies as soon as the knob is released
- Knob feels loose, sunken, or has stopped clicking
- Water or oil seeping under the hob glass
- Burnt smell or discolouration around the burner ring
What the visit covers
- Auto-ignition module and electrode testing and replacement
- Thermocouple / flame-failure device check on safety hobs
- Burner cap, crown and jet cleaning
- Knob and valve servicing, gasket replacement
- Re-sealing the hob to the platform cut-out
- Full leak test and flame calibration
Why it is worth fixing rather than replacing
The parts that actually fail on gas appliances — jets, nozzles, ignition electrodes, thermocouples, knob spindles, gaskets, regulators — are inexpensive and individually replaceable. The appliance body, which is the expensive part, almost never fails. That is why replacing a whole stove or hob for an ignition fault is usually the wrong call, and why Sunny will tell you honestly when something genuinely is beyond economical repair rather than selling you work that will not last.
Every visit includes a safety check
Whatever the booked job, the visit finishes with a soap-solution leak test across the joints, valves and hose, plus a flame check on every burner. Gas work that skips this step is not finished work. If something outside the booked job needs attention, you are told about it and given the cost — not charged for it unannounced.
Frequently Asked Questions
My hob keeps clicking even after the burner lights. Why?
Continuous clicking usually means moisture or spillage has bridged the ignition electrode, or the ignition switch is stuck closed. Both are common after a boil-over. Drying and cleaning the electrode fixes most cases; a failed switch or module is a straightforward replacement.
The flame goes out when I release the knob. Is that dangerous?
It is a safety feature working, or a safety feature failing. Hobs with a flame-failure device cut the gas when the thermocouple does not sense heat. If the thermocouple is dirty or worn, it cuts gas even when the flame is fine. It should be checked promptly — never wedge or bypass the knob.
Do you install new gas hobs as well?
Yes. That includes the platform cut-out check, gas connection, sealing, leak testing and a full flame calibration before handover. If you are moving from a freestanding stove to a built-in hob, the gas line usually needs modification too.